Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Danjel Rojka

#1
Hello, since the last time I installed my Galaxy Watch 4 I can't find and install the Locus Map Watch App in the Playstore. Have you changed anything or maybe withdrawn it?

I had the beta running.
#2
Locus Map Watch / Re: Wear for Locus Map beta testing
September 21, 2018, 17:02:03
Another thing, would it be possible to set and save the dashboards depending on the activity? Further it is only possible to set the dashboards when the recording is running. It is not possible to set the dashboards before.
#3
Locus Map Watch / Re: Wear for Locus Map beta testing
September 14, 2018, 09:19:29
Quote from: Danjel Rojka on September 12, 2018, 13:34:57
I use Nokia 7 Plus with Android 8.1 as Pure Android or Android One.

As Smartwatch I use the Polar M600 with current WearOS version. I can find out the exact version this evening.

On Polar M600 is Wear OS 1.5
HomeApp 2.15
Android 8.0
Security Patche  from 5.August 2018

On the Smartwatch the power saving function is deactivated.
#4
Locus Map Watch / Re: Wear for Locus Map beta testing
September 12, 2018, 16:24:43
I am always happy when I get positive feedback. This can narrow errors and exclude certain constellations.

Yesterday I had the problem that the connection or recording was not continuous. Presumably, this is due to the low battery level on the smartwatch.

But I have to verify that again.

I'll let you know.
#5
Locus Map Watch / Re: Wear for Locus Map beta testing
September 12, 2018, 13:34:57
I use Nokia 7 Plus with Android 8.1 as Pure Android or Android One.

As Smartwatch I use the Polar M600 with current WearOS version. I can find out the exact version this evening.
#6
Locus Map Watch / Re: Wear for Locus Map beta testing
September 11, 2018, 15:25:03
Am I the only one where it works reasonably well?

Best Regards
Danjel
#7
Locus Map Watch / Re: Wear for Locus Map beta testing
September 11, 2018, 09:17:00
Hello, Milan,

today I could test the pulse measurement again in bicycle mode. I rode my bike for about 50min and only had a drop-out of 10 seconds. Otherwise the transmission worked perfectly.

Best Regards
Danjel Rojka

#8
Locus Map Watch / Re: Wear for Locus Map beta testing
September 06, 2018, 13:05:53
Hello Milan,

the interruption of the cardiac frequency has only one interruption in an hour.
At 54min 26sec to 54min 46sec

Otherwise, I have a continuous transmission.

Best Regards
Danjel Rojka
#9
Locus Map Watch / Re: Wear for Locus Map beta testing
September 06, 2018, 10:05:37
No, I don't know.
#10
Locus Map Watch / Re: Wear for Locus Map beta testing
September 06, 2018, 09:57:32
I couldn't tell because I wasn't looking at the dashboard all the time. I'll check it on the next run to see if it happens.

You mean the dashboard on the Smartwatch or on the smartphone?
#11
Locus Map Watch / Re: Wear for Locus Map beta testing
September 06, 2018, 09:23:10
I can report that Wear Locus works without problems.
The heart rate was reproduced by Wear Locus without any problems. And I was able to finish my run successfully with the lap announcement and the heart rate message every 3min.
At the same time I started the Polar App on the Smartwatch and started the recording there. Both ran parallel and had no problems.

ˊ ` ` ` ` ` ` ` ` ` ` ` ` ` ` `'F'¯'''''L ` ` ` ` ` ` ` ` ` ` ` `
` ` ` ` ` ` ` ` ` ` ` ` ` ` ` `'[``...'¾`` ``` ``` ``` ```
` ` ` ` ` ` ` ` ` ` ` ` ` ` ` `'[```...ʹ[` ` ` ` ``` ``` ```
` ` ` ` ` ` ` ` ` ` ` ` ` ` ` `#````ˆ[```` ``` ``` ``` ``
` ` ` ` ` ` ` ` ` ` ` ` ` ` `'#``...``'[`... ` ` ` ` ` ` ` ` `
` ` ` ` ` ` ` ` ` ` ` ` ` ` #...`````'F`` ` ` ` `` ``` ```
` ` ` ` ` ` ` ` ` ` ` ` ` ƒ¯```````'[__` ` ` ` ` ` ` ``` ``
` ` ` ` ` ` ` ` ` ` ` ` ƒ¯````````ʹ¯¯¯¯''''''''''''¯¯¯¯¯¯™[ `
gµµµµµµµµµµµµµµ_µ™`````````````````````````'# `
'₫₫₫₫₫₫₫₫₫₫₫₫₫F¯...`````````````````````` ` ²q[¯ ` `
ʹ₫₫₫₫₫₫₫₫₫₫₫₫¾````````````````````````````ʹ} ... `
›₫₫₫₫₫₫₫₫₫₫₫₫#`````````````````````````__µr... ` `
³₫₫₫₫₫₫₫₫₫₫₫₫₫...`````````````````````````¯[ ... ` `
`₫₫₫₫₫₫₫₫₫₫₫₫$``````````````````````````_F ... ` `
`]₫₫₫₫₫₫₫₫₫₫₫#````````````````````````ʹ''''[... ... ` `
`'₫₫₫₫₫₫₫F''''']₫#___`````````````````````` '# ... ` `
...₫₫₫₫₫₫₫bµ₫₫₫₫$¯''''¹uuuuuɷuɷuɷuɷuɷuɷµ#¯ ` ` ` ` `
...'''''''™''''™'''™''''™™ ... ... ` ` ` ` ` ` ` ` ` ` ` ` ... ... ` ` `
` ... ` ` ` ` ` ` ` ` ... ` ... ` ` ` ` ` ` ` ` ` ` ` ... ` ` ` ` `.
#12
Hello Milan, I didn't find the time to install the beta. Should I do this after the fact?
Or is the problem fixed?

regards
Danjel
#13
Hello Milan,

On Saturday I tested the function outside and I had good GPS reception. I had the same issue.

Regards
Danjel
#14
Hello, Milan,
I have configured another sensor. This is the Mio link I connected via Bluetooth. But I also deactivated Bluetooth in Locus for connection with Mio when I started recording. With no other result. And Mio wasn't activated and connected either.
#15
Hello, Milan,

the screenshot does not always show the 3rd value with 4 but it is as you describe at 1 or 2 and also the first value is usually at 3.