Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - markopolo

#1
Dear LM users,

I have a question regarding "update elevation" feature and what/how it actually does. I am seeing (too) large increase in elevation after "update elevation" use on imported GPX tracks and on recorded ones.

I downloaded following GPX and followed it on bicycle:
https://drive.google.com/file/d/1DaYc2Gx8Fn1IBsduxEbepS9O_UNh5OXa/view?usp=drive_link

When I import it elevation shows:


After "update elevation" it shows:


According to my Garmin watch, actual measured elevation is very close to 1030m, rather then 1666m...

What could be the issue for this? I also noticed this in cases where I record track with LocusMap and later use "update elevation". The change in elevation is significant.

Thank you
#2
Hello Menion,

thank you for your reply. I understand. I will adjust the dashboard to be empty on the left side where navigation comes in...

Best regards
#3
Dear LocusMap users,

I am trying to combine Dashboard and Navigation panels into a single view. I am using LocusMap 3.70.1 (full version).

I have setup a Dashboard showing various parameters. When used without navigation, it looks nice and clean. However when I use it with navigation, I have an issue with overlapping. See image below.

You cannot view this attachment.

Is there a way to configure LocusMap, so that these two features are somehow stacked above/below to each other? See image below.

You cannot view this attachment.

Thank you