Messages

Dear LM users,

I have a question regarding "update elevation" feature and what/how it actually does. I am seeing (too) large increase in elevation after "update elevation" use on imported GPX tracks and on recorded ones.

I downloaded following GPX and followed it on bicycle:
https://drive.google.com/file/d/1DaYc2Gx8Fn1IBsduxEbepS9O_UNh5OXa/view?usp=drive_link

When I import it elevation shows:


After "update elevation" it shows:


According to my Garmin watch, actual measured elevation is very close to 1030m, rather then 1666m...

What could be the issue for this? I also noticed this in cases where I record track with LocusMap and later use "update elevation". The change in elevation is significant.

Thank you

Hello Menion,

thank you for your reply. I understand. I will adjust the dashboard to be empty on the left side where navigation comes in...

Best regards

Dear LocusMap users,

I am trying to combine Dashboard and Navigation panels into a single view. I am using LocusMap 3.70.1 (full version).

I have setup a Dashboard showing various parameters. When used without navigation, it looks nice and clean. However when I use it with navigation, I have an issue with overlapping. See image below.

You cannot view this attachment.

Is there a way to configure LocusMap, so that these two features are somehow stacked above/below to each other? See image below.

You cannot view this attachment.

Thank you