Author Topic: POI only loaded when needed  (Read 1439 times)

Offline jctmarques

  • More than Newbie
  • *
  • Posts: 32
    • View Profile
POI only loaded when needed
« on: May 02, 2011, 17:52:39 »
I would be very happy when I see this in Locus:
In map mode, only the POIs that are to be shown should be loaded. It's too slow to use a category with some thousand POI's.
For Geocaching, I think it should have a quick filter system (maybe set in preferences), so I don't see already found, inactive and Waypoints.
Also when I deselect the category and select again, the filter was reset.
« Last Edit: January 01, 1970, 01:00:00 by Guest »
 

Offline menion

  • Administrator
  • Professor of Locus
  • *****
  • Posts: 11169
  • Thanked: 265 times
    • View Profile
    • http://www.asamm.com
  • Device: SGS7
Re: POI only loaded when needed
« Reply #1 on: May 02, 2011, 21:22:12 »
this request was here already before ... but I don't have simple solution for it. To only show data, it's pretty simple. But I need to filter them, to sort them, to enable just part, to delete part .. hmm for me, only simple solution is to have all data loaded at once. category with 1000 points is loading below 1 sec, so I personally do not see big problem with this. But I'll try to think about it ...
« Last Edit: January 01, 1970, 01:00:00 by Guest »
Ideas, wishes, problems
Advanced topics, public discussion, sharing of knowledges, testing beta versions: you're here!