@ Andrew
Screen turns on continuously when stop at waypoint ? I did not observe that behaviour ? What is triggering this ? Your set up ? (Btw. 50m:5m/sec = ? sec)
@0709 - while using
guiding mode (I believe you mainly test navigation mode, maybe different?) - when you are reaching the next navi waypoint, and the display is automatically turned on, if you then manually turn it back off Locus will just turn it back on again, about every second or two, until you have gone sufficiently past the waypoint; so - if you stop at the waypoint (or end of track) there is no way to turn off the display except to cancel guiding; this is not so good because it takes quite a few taps to re-enable guiding - when cancelled the track is hidden, so go to Data > Tracks > Folder > Track > unhide > or maybe guide
a navigation/ guiding pause feature would be nice

then you could go "off track" for a while then resume navigation/ guiding a little later
>Btw. 50m:5m/sec = ? sec
I was just quoting another person, not my maths, 50m @ 5m/s = 10s - did I pass?