Topics

While manually modifying track points, especially while adding points, the height information of the point seems to be calculated (or ignored). After updating the height information (using the 'Tools/Refresh Elevation'), a good approximation of the elevation is applied to the entire track, but a lot of detail, collected by the GPS, is lost.
Would there be a way to apply the 'Refresh Elevation' tool to just a part of the track, or is there a way to adjust the elevation information of selected point of the track?

Raw data from GPS:
You cannot view this attachment.

After applying the Refresh Elevation tool:
You cannot view this attachment.

The trackline which is shown on the map, at certain points, show a gap (interruption of the line). I cannot get rid of this gap by editing (remove the points at the location of the gap). Is there a way to let the lines join?

You cannot view this attachment.